Your location: Conveyor> News Center> News Center
High-inclined belt conveyor adopts air cushion device to achieve smooth operation Among the many conveyor systems, belt conveyors are the most common. Mainly because the cost performance of the belt conveyor is too high, the cost is low, the operation is stable, the structure is simple and easy to install, and the belt conveyor looks very simple. In fact, there is a lot of knowledge in it. There are many kinds of picking for the conveyor belt. For example, there are PVC materials, rubber materials, silicone materials, etc., which depends on the goods transported by customers.
As one of the main conveying equipments in the cement industry, the belt conveyor with large inclination angle has been used for many years. There are many disadvantages in use, such as large resistance, large power consumption, and vibration of the belt during operation. Wait, there has been no major improvement over the years. Air-cushion belt conveyors were first widely used in the grain industry and wharves, etc., and have only been used in the cement industry in recent years. The effect is obviously better than that of a roller conveyor. The characteristics and principle of the air cushion belt conveyor from the conveyance of the material are not much different from those of the roller belt conveyor, but the structure is improved. A layer of air film is formed between the belt and the air chamber. The belt runs on this layer of air film, so the resistance is much smaller than the resistance of the idler. Because the entire belt is fully supported by the air chamber, there is no gap in the middle, so the operation is relatively stable.